ENGINEERING-43 Series-Parallel Circuits Lab-06 Lab Data Sheet – ENGR-43 Lab-06 Lab Logistics Experimenter: Recorder: Date: Equipment Used (maker, model, and serial no. if available) Directions 1. Check out a DMM. 2. Go to the side counter, collect resistors, “bread board”, and leads required to construct the circuit shown in Figure 1. 3. Make the DMM-Measurements1 and Calculations needed to complete Table I Measure RT, the total circuit resistance, by removing the power supply, and applying in the ohmmeter probes across the input & output circuit connections. Calculate RT using two different methods o By the Series-Parallel calculation from the individually measured resistances o By V/I using the measured values of Current & Voltage The experimenter must determine WHICH I & V to use in this calculation 4. Return all lab hardware to the “as-found” condition 1 CAREFULLY Select the DMM range such that meter displays at least FOUR (4) digits. All DMM measurements should be reported to 4 significant figures © Bruce Mayer, PE • Chabot College • 282235922 • Page 1 NOTE The Ammeter MUST be connected in series with NO potential across it; i.e., do NOT connect the ammeter ACROSS Vs or any R. Figure 1 • Series-Parallel Circuit. - Vs = 10.00 Vdc. - R1 = 0.8-4 kΩ = R2 = 0.8-4kΩ = R3 = 0.8-4 kΩ. R4 = 1.2-9 kΩ. - R1, R2, R3 to have the SAME nominal (color-coded) value. - The R1,2,3:R4 Resistance RATIO to be in the range of 1.5-6 . © Bruce Mayer, PE • Chabot College • 282235922 • Page 2 Actual Values Vs = R1 = R2 = R3 = R4 = Table I – Full Circuit Characterization Value Determination RT (note1) RT (note2) VR1 VR2 VR3 VR4 I1 I23 Calculated Measured % Note1: Calculate by Series-Parallel combination using the Actual Values for resistors R1-R4 as determined by OhmMeter measurement Note2: Calculate using appropriate I & V measurements % calculation % = 100x(Valuecalc – Valuemeas)/Valuemeas Run Notes/Comments © Bruce Mayer, PE • Chabot College • 282235922 • Page 3 I4