Industrial/Technical
Industrial Technologies
Instrumentation & Controls Certificate
Specific Program Requirements
306100 Approved 8/2009 (Spring 2010)
Credits
CSIS 123
EHSS 111
Programming Fundamentals
Intro to Health & Safety for General Industry
3
1
ETEC 110
Basic Electronics Principles
3
ETEC 118
AC Circuit Analysis
3
ETEC 130
Digital Electronics
4
ETEC 230
MATH 120
MATH 130
MATH 150
Microcomputer Architecture
College Algebra and
Trigonometry or
Precalculus
4
ETEC 111
INTE 175
INTE 270
INTE 271
Microcomputer Hardware Repair
Electric Motor Controls I
Instrumentation & Process Control
Programmable Logic Controllers I
5-6
Electives: Choose three of the following:
Total Credit Hours Required
9
32-33
Semester
Taken
Prerequisites
MATH 40/40L or appropriate placement score
Completion of or concurrent enrollment in MATH
103 or higher
ETEC 110 or INTE 110
Completion of or concurrent enrollment ETEC 110
or INTE 110
ETEC 130
MATH 110 or appropriate placement score
MATH 120 or appropriate placement or score
MATH 110 or appropriate placement score
CSIS 110
HVAC 109 or INTE 115
INTE 225 and INTE 272
INTE 110 and INTE 175
Non-Degree Related Courses____________________________________________________________________________________
___________________________________________________________________________________________________________
Advisor/Counselor/Evaluator________________________________________Date______________________
_____ Hrs Earned _____ MCC GPA _____ Hrs Enrolled _____ Hrs in Res _____ Hrs Needed
TO GRADUATE THE STUDENT MUST SUCCESSFULLY COMPLETE THE FOLLOWING:
____ Apply for Graduation
_____ Additional courses to meet total credit hour requirement
____ Missouri Constitution Requirement (including current coursework)
____ Raise/Maintain GPA to 2.5 _____ Any course substitutions/waivers must be approved using
____ Additional courses to meet the 15 credit
an “Student Exception to Graduation” form
hour residency requirement _____ Minimum score of 235 on each section of C-BASE