DANSE CORPORATION
MATERIAL SAFETY DATA SHEET
TOTAL PAGES 3
SECTION I – GENERAL INFORMATION
MANUFACTURER
ADDRESS
PHONE NUMBER
Danse Corporation
1201 E. Whitcomb Ave.
Madison Heights, MI 48071
(248) 583-1007
TRADE NAME & SYNONYMS
Highpoint Ridge Vents
Highpoint Standard 50 Vent
FORMULA
Injection Molded Plastic Copolymer
SECTION II - INGREDIENTS
PRINCIPLE HAZARDOUS COMPONENTS
None
PERCENT
N/A
THRESHOLD LIMIT VALUE (UNITS)
N/A
SECTION III – PHYSICAL DATA
BOILING POINT (° F)
N/A
SPECIFIC GRAVITY (H20=1)
0.895-0.92 g/cm3
VAPOR PRESSURE (MM HG.)
N/A
PERCENT VOLATILE BY VOLUME (%)
N/A
VAPOR DENSITY (AIR = 1)
N/A
EVAPORATION RATE (WATER = 1)
N/A
SOLUBILITY IN WATER
Insoluble
PH
N/A
APPEARANCE & ODOR
Molded Black Ridge Vent, Molded
Black, Brown, Gray or Weathered
Wood Box vent.
No appreciable odor.
VISCOSITY (@ 77° F)
N/A
MSDS 1/2/04
1
DANSE CORPORATION
SECTION IV – FIRE & EXPLOSION HAZARD DATA
FLASH POINT (TEST METHOD)
650°F
AUTO IGNITION TEMPERATURE
1058°F
FLAMMABLE LIMITS
N/A
EXTINGUISHING MEDIA
Water, Foam, CO2 , Dry Chemical
SPECIAL FIRE FIGHTING PROCEDURES
Wear appropriate safety equipment
for fire conditions including
NIOSHA/MSHA self-contained
breathing apparatus (SCBA) and
other protective equipment and/or
garments as described in Section VIII
if exposure conditions warrant. Use
water fog or spray to cool exposed
equipment and containers.
UNUSUAL FIRE & EXPLOSION HAZARDS
N/A
SECTION V – HEALTH HAZARD DATA
THRESHOLD LIMIT VALUE
N/A
OSHA THRESHOLD LIMIT VALUE
N/A
ACGIH THRESHOLD LIMIT VALUE
N/A
CARCINOGEN – NTP PROGRAM
N/A
CARCINOGEN IARC PROGRAM
N/A
SYMPTOMS OF EXPOSURE
N/A
MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE
N/A
PRIMARY ROUTE(S) OF ENTRY
N/A
SECTION VI – REACTIVITY DATA
STABILITY
Stable
INCOMPATIBILITY
Oxidants
HAZARDOUS POLYMERIZATION
Will not occur
HAZARDOUS DECOMPOSITION PRODUCTS
Carbon oxides and various
hydrocarbon gases.
MSDS 1/2/04
2
DANSE CORPORATION
SECTION VII – ENVIRONMENTAL PROTECTION PROCEDURES
SPILL RESPONSE
Pick up pieces
WASTE DISPOSAL METHOD
Dispose in accordance with local, state
and federal requirements.
SECTION VIII – SPECIAL PROTECTION INFORMATION
EYE PROTECTION
Use is recommended.
PROTECTIVE GLOVES
Use is recommended.
RESPIRATORY INFORMATION
None
SECTION IX – SPECIAL PRECAUTIONS
HYGIENIC PRACTICES IN HANDLING & STORAGE
MSDS 1/2/04
Observe ordinary measures for
industrial hygiene.
3