Lab #1
Follow the instruction and procedures in the Student Manual, unless specified differently
in this note.
Reading:
Class 1 and Lab 1 in Student Manual (SM)
To 1.9 in The Art of Electronics (AE).
Lab #1
1-1 Follow the instruction for this part.
When you present your data, try to make graphs. Verify Ohm’s law (at least 2
resistors) and compare the known values of the resistance with what you measured
through the Ohm’s law (slope in I-V graph).
Answer the questions posed in Effects of the instruments on your readings.
To estimate the error in “a quantitative view,” you need to measure the internal
resistances of the DVM in ammeter and voltmeter mode, and calculate their effect on
the measured voltages and currents. You can measure the internal resistance by
constructing a simple voltage divider. Ask the instructor if you cannot figure out
how to measure the internal resistance.
1-2 Follow the instruction and answer all the questions posed.
1-3 Follow the instruction and make plots in the linear and semi-log plot.
Measure with both positive and negative voltages from the power supply.
Additional question: What is the role of 1k resistor in the circuit?
You do not have to give answers to the questions posed on p.28.
1-4 Follow the instruction. Very important to understand a voltage divider.
1-5 Get familiar with the oscilloscope (OSC).
You do not have to write this part in the report.
1-6 Get familiar with the function generator (F/G).
You do not have to write this part in the report.