AIM
Armstrong’s Intelligent Monitoring
Training presentation
Ever Had a Request For?
 New Construction
 Trailers /Boats
 Camps / Cottages
 Drop Boxes
 Cargo Containers
 Construction Trailers
 Emergency Temporary
System
AIM Designed for…
AIM is designed for small application for use on construction
sites, boats, trailers, RV’s, Cottages or anywhere there is no or
limited power available.
This independent system that does not require phone lines or
hardwired AC Power as it utilizes a self-contained battery power
source allowing you to place the AIM unit where it will be most
effective.
The special design of this unit will run 30 – 60 days without
recharging the battery and can be installed with a solar panel
giving unlimited run time.
AIM is the affordable
solution…
There are 3 kits available at Tri-Ed they are pre-assembled and
programmed.
(ARM -1450HW-hardwire, ARM-1450WL-wireless and ARM1450-PC portable wireless)
Each kit includes an AIM board, GSM (Rogers) Custom Uplink
Radio, Keypad or Keyfob
Instruction Manual and Activation Form
They are compatible with the Visonic powercode line of
peripherals.
1450 HW - Hardwire
1450HW - Wired Assembled Kit
AIM 8 Zone Board (5 N/C zones,1 N/C
24 hour zone,2 N/O zones), Custom
Uplink Radio, Custom Molded Housing,
Visonic CL-8 Keypad, fully assembled
and programmed.
System comes preprogrammed. For
installation simply connect batteries,
install the key pad and the Visonic
powercode devices for your specific
application. (note any hardwire peripheral
can be installed but must have battery
support).
1450-WL Wireless
AIM - Wireless Assembled Kit
AIM 7 Zone Board (4 independent zones and 3
supervisory zones), Custom Uplink Radio, 1Visconic MCR-308 Wireless Receiver, 1Visonic MCX-8 Expander, Custom Molded
Housing, Visonic MCM-140 Wireless Keypad,
all fully assembled and programmed.
System comes preprogrammed. For installation
simply connect batteries, install the key pad
and the Visonic powercode devices for your
specific application.
1450 – PC Portable
Wireless Case
AIM - Wireless Portable Case
AIM 8 Zone Board (3 Wireless zones, 1 tilt tamper, 3
supervisory, and 1 spare zone for optional case
detector), Custom Uplink Radio, 1- Visonic Key
Fob, 1 - Visonic Wireless Door Contact, 1Visonic Wireless Motion Detector, 1-Visconic
Wireless Receiver, 1 durable Pelican Case, 2 - 7
amphr batteries, hardwire transformer to
recharge the batteries.
This unique portable system is water tight
and can be used in many different
applications including temporary
system, and covert operations.
Power Efficiency
Development
•
With 2 -7amp non recycled lead
batteries the AIM unit will operator
30 days and up to 60 -90 days on
larger battery (car, boat, etc..)
•
Continual power with optional
solar panel charger
How does it work?
 1450 HW (hardwire) draws only 13 mA of power while




on standby and the 1450WL draws 28 mA of power.
By using the Visonic power code of peripherals each
device is self powered drawing no additional power
from the main board.
Our board puts the radio on standby until a device is
triggered, which at that time our board then activates
the radio.
Radio then sends signal and awaits kiss off.
Once signal verified the unit then goes back on
standby.
Technical Specification
1450-HW board
• 5 zones are normally closed loops.
• 1 Zone 24 hour for smoke, medical,
etc…
• 7 & 8 are N/O zones and can
accommodate ground switch where
required.
• Exit/entry delay zone.
1450-WL Features
 4 independent fully supervised zones
 3 fully supervised (tamper, low battery,





and device supervision)
Zone 1 Entry / Exit delay (J1 turned on) 45 second delay
Test signal with voltage reading
Buffer signals
Alarm and Restore
LED for status reading off board
1450-PC Features
 3 wireless zones, 1 tilt tamper, 3







independent fully supervised
zones (tamper, low battery,
and device supervision), and 1 spare
zone for optional case detector
Optional case detector
Entry / Exit signals 45 sec delay
Test signal with voltage reading
Buffer signals
Alarm and Restore
LED for status reading
Keyfob
Status
• Hardwire or wireless has and led
status on AIM board external LED
can be added.
• On arming and disarming two tone
chime will indicate status of system.
1 – tone armed 2 tones disarmed.
• 2 amp N/O relay can be used for 15
watt siren. (60 second sound).
VISONIC Detectors
AIM works in conjunction with the
Visonic powercode line of
peripherals, so AIM can be custom
designed for any application
•
•
•
•
VISONIC NEXT K9-85 motion
detector
VISONIC SRN C PC motion
detector has contacts for
hardwiring directly to the aim
panel.
VISONIC MCT-425 smoke
detector
VISONIC MCT-201 is a pendent
that can be used to turn on/off the
AIM unit wirelessly
Notification
More than Security
For the applications that are not
fixed such as a RV or Boat
dealers can ask their station
about end user self
management.
•Notification can be sent to the
end users PDA / Cellular phone
(ask your monitoring centre for more details)
• Direct Operator notification
Signal Reporting
 Panels transmits in Contact ID
 Transmits alarm and restore, trouble, arming/disarming,
daily test (includes battery voltage)
E602128 = E602 test and12.8 battery voltage
 Panel can only transmit the same zone three times within
the hour.
 In case of cellular signal loss the unit will stay awake for
a maximum of 4 minutes trying to send data. If unable to
send then the unit will shut down for 30 minutes and retry
up to 5 times before it will buffer the alarm and send with
next transmission
Notification Signals
22-01-5020 02/02/09 9:17
Smith Construction Site
E400000 AIM System On
Employee/User #00
22-01-5020 02/02/09 10:00
Smith Construction Site
E140001 Front Door
22-01-5020 02/02/09 9:18
Smith Construction Site
E602127 Test Signal
22-01-5020 02/02/09 10:02
Smith Construction Site
R140001 Restore – Front Door
Questions …
Is the Aim affected by temperature?
• Tested to +40c and -40
How do we activate the system?
• Unit is fully activated upon delivery.
Where does the system notification work?
• Notification works throughout North America,
where ever GSM is available.