SECTION 10 56 13
METAL STORAGE SHELVING
PART 1
GENERAL
1.01 SUMMARY
A.
Section Includes:
1.
Metal Storage Shelving
1.02 SUBMITTALS
A.
Submit "Letter of Conformance" in accordance with Section 01 33 00 (01330) with the
following supporting data:
1.
Mark each copy to identify applicable products, characteristics, models, options and other
supplemental data to clearly communicate information specific to this project.
2.
Color Chart: Each product specified.
1.03 QUALITY ASSURANCE
A.
Installer Qualifications: Manufacturer's authorized representative who is trained and approved
for installation of units required for this Project.
B.
Source Limitations:
manufacturer.
Obtain metal storage shelving through one source from a single
1.04 DELIVERY, STORAGE, AND HANDLING
A.
Deliver metal storage shelving palleted, wrapped, or crated to provide protection during transit
and Project-site storage.
1.05 PROJECT CONDITIONS
A.
Environmental Limitations: Do not deliver or install metal storage shelving until spaces are
enclosed and weatherproof, wet work in spaces is completed and dry, and ambient
temperature is being maintained at the levels indicated for Project when occupied for its
intended use.
1.06 COORDINATION
A.
PART 2
Coordinate locations and installation of metal storage shelving that may interfere with ceiling
systems including lighting, HVAC, and sprinklers.
PRODUCTS
2.01 STORAGE SHELVING
A.
Avendra, LLC Preferred Manufacturers:
1.
B.
None
Approved Manufacturers:
1.
"Open Clip Type Shelving" - Republic Storage Systems Company (800-477-1255)
2.
"Clip - Support Shelving" - Adapto Storage Products, (800-923-2786)
3.
"8000 Series" - - Lyon Workspace Products, LLC (800-433-8488)
4.
"Clipper Shelving" - Penco Products, Inc (800-562-1000)
▪ SECTION 10 56 13 (10670) - METAL STORAGE SHELVING ▪
▪ PAGE 1 ▪
FILE: 533567169
 2007, Marriott International, Inc.
REVISED: 09/28/07
CFRST SPECMSTR-NEW BUILD
C.
Design:
1.
D.
E.
PART 3
a.
3'-0" Long Units: Minimum 800 pounds load capacity per shelf.
b.
4'-0" Long Units: Minimum 550 pounds load capacity per shelf.
Components:
1.
Angle posts; 13 gage steel, with slots to receive shelf clips.
2.
Shelves: 18 gage steel. Front and back shelf flanges turned down to accommodate 1" x
1" x 1/8" reinforcing angles.
3.
Shelf Clips: Type recommended and used by shelving manufacturer for required loading.
4.
Sway Braces: 1" x 1/8" band iron with holes at ends for attachment to shelving units.
5.
Accessories: As required by classification, design and installation requirements.
Finish:
1.
F.
Stand alone clip type consisting of 4 angle posts, 2 back sway braces, 4 side sway
braces and 6 shelves.
Factory finish in manufacturers standard color selected by Owner’s representative.
Size and layout as indicated on the Drawings.
EXECUTION
3.01 INSTALLATION
A.
Set units plumb, level and square. Do not secure to adjacent walls. Adjust for rigidity.
END OF SECTION
▪ SECTION 10 56 13 (10670) - METAL STORAGE SHELVING ▪
▪ PAGE 2 ▪
REVISED: 09/28/07
CFRST SPECMSTR-NEW BUILD
FILE: 533567169
 2007, Marriott International, Inc.