Article VI.
“RR” Rural Residential District
Section 49.
Purpose and Intent. The purpose of the “RR” Rural Residential District is to recognize
existing low-density residential development in already-developed areas. Most of these
areas are located in agricultural areas or on the outskirts of unincorporated villages.
Rezoning s to RR will not be permitted except to remedy inconsistencies – i.e., for
existing dwellings of record adjacent to already-platted “RR” districts, or to correct
discrepancies in zoning district boundaries.
Section 50.
Permitted, Conditional, Interim and Accessory Uses in the Rural Residential
District
Section 51.
A.
Permitted, conditional, interim and accessory uses of land are as specified in the
table in Article III, Section 24.
B.
Permitted and conditional or interim uses may be combined on a single parcel,
provide that each use meets the general, density, specific and performance
standards of this Ordinance and any other applicable provisions of this
Ordinance.
Dimensional Standards.
A.
Minimum lot area for single-family dwelling. The minimum lot size for a
single-family dwelling shall be 20,000 square feet.
1.
An increase in maximum lot area may be required to provide for a
sewage treatment system as required by this Ordinance.
B.
Minimum lot width. The minimum lot width shall be one hundred (100) feet.
C.
Minimum front yard setback. The minimum front yard setback shall be the
average setback of the residential buildings fronting the same side of the street on
the same block, but shall be no closer than 35 feet.
D.
Minimum side yard setback. The minimum side yard setback shall be ten (10)
feet.
E.
Minimum rear yard setback. The minimum rear yard setback shall be 25 feet.
F.
Maximum height. The maximum height for buildings is as follows:
1. Principal buildings
2. Detached airplane hangers
3. Other accessory buildings
Sections 52-58.
Reserved.
35 feet
24 feet
16 feet