• Up to 48 Mbps air interface throughput*
• Net payload is 18 Mbps, full-duplex
• Combination of E1 or T1 and Ethernet
• Range up to 80 km/50 miles*
• Carrier-class performance
• RADview SNMP network fault management
• Easy to install
* Rate is adaptive to range
AirMux-200 Product Launch Slide 2

Released
• 5.725 - 5850 GHz
• Up to 2 x E1 or 2 x T1, and Ethernet
December 2004 Pre-Release Version
• 5.250-5.350 GHz
• 2.400-2.4835 GHz ETSI and FCC regulation
• 4 x E1 or 4 x T1 ports, and 2 x Ethernet ports
• Carrier-class indoor unit (IDU)
• Power over Ethernet IDU
February 2005 Pre-Release Version
• 5.470-5.725 GHz complying with ETSI and FCC
• Supports Transmit Power Control (TPC) and Dynamic
Frequency Selection (DFS)
• Encryption: according to AES 128
AirMux-200 Product Launch Slide 3

Server
Switch
Remote Site
LAN
V24 n x FXS
V.35
Megaplex n x E1
AirMux-200
Up to 80 km/50 miles
AirMux-200
HQ
Switch
LAN
PBX n x E1
Router
Main Drivers
• Fast ROI versus leased lines
• Fast deployment and equipment reuse
• Broadband infrastructure enabler
• Backup for terrestrial lines
Packet
PSTN
AirMux-200 Product Launch Slide 4

• ODU with integrated antenna, includes pole and wall mount brackets
• ODU for connecting an external antenna, includes “N” type connector
• Standard outdoor
Cat.5e cable for connecting ODU to IDU
AirMux-200 Product Launch Slide 5

IDU – Standard indoor unit
• Ethernet
• Ethernet + E1 or T1
• Ethernet + 2 x E1 or 2 x T1
IDUE – Carrier-class indoor unit
• 2 x Ethernet + 4 x E1 or 4 x T1
IDUD – Power over Ethernet unit
• Ethernet
AirMux-200 Product Launch Slide 6

Frequency Bands 5.725-5.850 GHz ^
5.470-5.725 GHz *
5.250-5.350 GHz ^
2.400-2.4835 GHz *^
20 MHz
Via NMS, 5 MHz Resolution
Channel Bandwidth
RF Channel Selection
Standard
Polarization
Antenna Gain (dBi)
FCC, *ETSI, ^CAN/CSA
Linear (V or H)
Integrated
22 (5.x GHz)
17 (2.4 GHz)
External
28 (5.x GHz)
24 (2.4 GHz)
Antenna Beamwidth 9.0 degrees
Sensitivity (dBm)
@ BER < 10e-11
-84 -81
Rate (Mbps)
Modulation
12
BPSK
18
QPSK
4.5 degrees
-74
36
16QAM
-68
48
64QAM
AirMux-200 Product Launch Slide 7

Air Interface
Rate
Throughput full-duplex
Throughput left for Ethernet traffic when using TDM Service
Maximum
Range
(Mbps) (Mbps) 1 x E1 2 x E1 1 x T1 2 x T1 (km) (miles)
12
18
4.2
6.5
2.0
4.4
N/A
2.3
2.5
4.8
0.88
3.2
41
25
25.5
15.5
36
48
13.6
18.3
11.5
16.2
9.3
14.0
11.9
16.6
10.2
14.9
10
4
6.0
2.5
* Figures are for 22 dBi integrated antenna, at 5.725-5.850 GHz band.
Maximum range is 80 km/50 miles with 28 dBi antenna at same band.
AirMux-200 Product Launch Slide 8

• Jitter and wander according to G.823.4
• Clock recovery (<0.05 PPM)
• E1 delay is 8 msec
• TDM circuit BER < 10e-11 @ sensitivity threshold
• Ethernet delay less then 3 msec
• Lossless Ethernet traffic
AirMux-200 Product Launch Slide 9

Airmux Manager:
• SNMP-based
• Installation wizard
• Link-based configuration for management of link with single IP address
• On-line monitoring of air interface, E1/T1 and Ethernet services
• Maintenance
• E1/T1 Local and Remote loopbacks
• Over-the-air software upgrade
RADview SNMP Network Fault Management
AirMux-200 Product Launch Slide 10

• No need for digital volt meter (DVM)
• Survey performed by ODU
• Audio indication for optimal received signal strength (RSS)
• Per-link configuration and settings
• Unique system signal identification
• No pre-installation setting is required
• Light-weight ODU
AirMux-200 Product Launch Slide 11

Frequency
5.725-5.850 GHz FCC,
CAN/CSA
License-free Coverage Region
USA, Canada, Mexico, Brazil, Argentina, China,
Australia, New Zealand, Taiwan, Hong Kong, UK*, Spain
5.470-5.725 GHz FCC
5.470-5.725 GHz ETSI
USA
Germany, Italy*, Belgium, Denmark, Sweden, Finland,
Ireland
5.250-5.350 GHz FCC,
CAN/CSA
2.400-2.483.5 GHz FCC,
CAN/CSA
USA, Canada
USA, Canada, Taiwan
2.400-2.483.5 GHz ETSI Most EU countries, Israel
* Special limitations or requirements may apply here
• Regulated coverage in many other regions
AirMux-200 Product Launch Slide 12

• AirMux-200 provides a high return on investment in a variety of campus, enterprise and service provider applications. These include:
•
•
•
•
•
•
•
•
•
•
Lossless Hot Spot Backhauling
Telephone Service Extension to Remote/Rural Locations
Multiple Services in Daisy Chain Topology
Multiple Services with Unique E1/T1 Ring Protection
Emergency Services and Temporary Deployment
Wireless Backup
Interconnecting Multiple Legacy Services over Packet Networks
Cellular Backhaul
Cellular Backhaul with TDMoIP Mesh Protection
Voice Traffic Extension over Wireless
AirMux-200 Product Launch Slide 13

Hot Spot
Ethernet
Access Point
AirMux-200
5.x or 2.4 GHz
ISP
Ethernet
AirMux-200
Router
Packet
• Supports full 5.x GHz and 2.4 GHz bands for lossless hot spot backhauling including band and channel separation
• Transparent Ethernet forwarding
• Ethernet and power over Ethernet ODU/IDU connection
AirMux-200 Product Launch Slide 14

5.x or 2.4 GHz
CPE
Remote/Rural Location
MP-104/204
E1
AirMux-200
CPE
Remote/Rural Location
MP-104/204
E1
AirMux-200
5.x or 2.4 GHz
AirMux-200
E1
MP-2104/2100
E1
PSTN
AirMux-200
Central Site
• Extends telephony services to remote or rural areas
• Megaplex units serve as channel banks at the remote end, and as aggregation devices at the center
AirMux-200 Product Launch Slide 15

V.52
MP-2104
AirMux-200 AirMux-200
MP-2104
AirMux-200 AirMux-200
FCD-IP FCD-IP
• Drop-and-insert topology saves cost of lease lines or infrastructure investment
• Drop of any service
• Optimized solution for specific node requirements
• Target markets: utilities, cellular, transportation
AirMux-200 Product Launch Slide 16

Fire Alarm
FCD-IP
MP-2104
4 x E1/T1
Ring
Typical users:
• Campus
• Cellular
• Utilities
MP-2100
NMS
Servers
PBX
• Unique ring protection
• Optimized solution for specific node requirements
• Any service
AirMux-200 Product Launch Slide 17

Switch
Remote Site
Megaplex n x E1 AirMux-200
AirMux-200
Central Site n x links
AirMux-200
Switch
DXC
• Enables mobility and fast deployment
• Typical users: military, emergency services, broadcast, etc.
AirMux-200 Product Launch Slide 18

Site A
AirMux
CPE
G.703
DXC
F.O or Copper
AirMux
Site B
DXC
G.703
CPE
RADview
NMS
• Automatic switch-over with DXC
• Typical users: financial organizations, government, military
AirMux-200 Product Launch Slide 19

AirMux-200
AirMux-200
V.35
Router
IPmux-14
Ethernet
LAN
4-16
E1/T1
IPmux-8/16
Ethernet
Ethernet
Services PBX n x E1/T1
IPmux-14
Ethernet
LAN
NMS
Ethernet over Fiber
Cable PLC
• End-to-end transmission of multiple user services over IP, with central demarcation and aggregation IPmux units
• Adds Ethernet traffic engineering tools such as rate limiting and
VLAN stacking
• End-to-end service provisioning with RADview-SC/TDMoIP
AirMux-200 Product Launch Slide 20

BTS Site
BTS n x E1
10/100BT
AirMux-200
AirMux-200
BSC Site
Switch n x links
BTS Site
BTS n x E1
Ethernet
AirMux-200
AirMux-200
• Integration of cellular, monitoring and management traffic
• Future migration to IP 3G BTS
• Cost-effective alternative to
Microwaves
• High link availability
DACS
BSC
E3
Packet
TDM
• 0.05 ppm clock recovery
• 8 msec E1 or T1 delay
• 3 msec Ethernet delay
AirMux-200 Product Launch Slide 21

®
BTS Site
BTS
1-4 x E1
IPmux-14
2 x 10/100BT
AirMux-200
BTS Site
BTS
1-4 x E1
IPmux-14
2 x 10/100BT
AirMux-200
AirMux-200
BSC Site
Up to 16 x E1
BSC n x links
IPmux-16 n x F.Eth
AirMux-200
Backbone
• Complies to clock accuracy, jitter and wander
GSM requirements
• Protection via packet ring or mesh topology
• 25%-50% equipment savings versus 1+1 protection
AirMux-200 Product Launch Slide 22

Headquarters
Vmux-2100 Router
AirMux-200
Up to 80 km/50 miles
AirMux-200
Branch #1
Vmux-110
E1/T1
PBX
E1/T1
PBX
E1/T1
PSTN
IP / TDM
Network
IP or
E1/T1
Branch #2
Vmux-110
E1/T1
PBX
• High link utilization with up to 16:1 compression ratio
• Enables extending E1 or T1 over IP for up to
80 km/50 miles
AirMux-200 Product Launch Slide 23

• Best price/performance in the industry - Fast ROI
• Combination of up to 4 x E1/T1 plus Ethernet, with high traffic throughput
• High link availability with carrier-class performance
• Reduction of deployment time and expenses as part of a complete interoperable solution with other RAD devices
(e.g. Megaplex Multiservice Access Multiplexers)
• Management of hundreds of links and access devices from a single SNMP fault management application
• Enhanced security with standard encryption mechanism
• Easy deployment via installation and alignment tools
AirMux-200 Product Launch Slide 24

Tel: 1-888-785-7393
Int’l: 1-951-694-1173
Email: airmux@pulsewan.com
www.airmux.com
AirMux-200 Product Launch Slide 25