Step 1. Configure Hyper-terminal to communicate with SC serial
interface through Com 1 serial port
Connection
speed at
115200
Flow control
to “None”
1
Step 2A. Configure Hyper-terminal to communicate with SC
serial interface through Com 1 serial port
Emulation
VT100
132 column
mode
ASCII
2
Step 3. Push Reset button or Turn Abacus50 Off then
ON to restart system
3
Step 4. Before count down to zero, press any key
to stop auto booting procedure
Step 5. The HyperTerminal window will display four
options, change the network configuration and save
settings
Step 6. After updating, Abacus will reboot and you can
check the new configurations during boot procedure
6