EM556S DIGITAL MICROSTEP DRIVE
The Leadshine CS-D570E is a closed loop stepper drive designed to solve the step loss problem in open loop stepper
control systems, increasing system reliability at a low cost. It is capable of powering 2-phase NEMA 23, 24, and 34
stepper motors equipped with incremental encoders. In comparison to standard open loop stepper systems, a CSD1008E adopted closed loop step system eliminates potential step loss, performs real-time position error correction,
and does not require torque reservation. It can also power the driven stepper motor with less heating, noise, and
vibration.
S2: DIP SWITCH
S3: CONTROL SIGNAL VOLTAGE SELECTOR
(5V or 24V)
S1: ROTATING SWITCH
CS-D507E Closed Loop Motor
1. DIP SWITCH CONFIGURATIONS
1.1. S1 – Rotating Switch Configurations
Rotating Switch is set to 0.
1.2. S2 – DIP Switch Configurations
1.2.1. Micro Step (SW1-SW4)
The DIP switch “Pulse/rev” is set to 800.
PULSE/REV
SWITCH
ON OFF
SW1
SW2
SW3
SW4
1.2.2. Mode Setting (SW5-SW8)
Mode Setting
SWITCH
ON OFF
SW5
SW6
SW7
SW8
Actual DIP Switch Configurations
1.3. S3 – Control Signal Voltage Selector Configurations
The 1-bit selector is located on the top is used to configure the voltage of control signals. For safety
reasons, the factory setting is 24 V. When the voltage of the control signal is 5V, the S3 must be set to
5V, otherwise, the motor will not work.
24V
5V
Control Signal Voltage Selector is set to 24V.