DSO1000S Series Handheld Oscilloscope/Multimeter
Isolated level:1000V CATII,600V CATIII.60MHz-200MHz Bandwidth Oscilloscope,1GSa/s sample rate,1M Memory Depth, and 6000
Counts DMM with analog bargraph.5.6 inch TFT Color LCD Display，High Resolution(640*480）
Feature
• Isolated level:1000V CATII,600V CATIII.
• High Bandwidth 60MHz-200MHz Oscilloscope,1GSa/s sample rate, and 6000 Counts DMM with analog bargraph , and
data recorder.
• 1M Memory Depth.
• High Refresh Rate (2500 frames)
• Large 5.6 inch TFT Color LCD Display，High Resolution(640*480）, Dual-Window Design --More clear, More Detailed
• One-touch automatic setup optimizes the position, range, timebase, and triggering to assure a stable display of virtually
any waveform
• Easy-to-use pop-up menu with built-in multi-language help system
• 23 Automatic Measurements
• Waveform Math: Add, Subtract, Multiply, and Divide
• Store and recall over
• Automatic cursor tracking measurements
• XY Mode
• Built-in FFT function converts a time-domain signal into its frequency components to measure harmonic content and
distortion in systems
• Waveform Recorder to capture/replay input waveforms from CH1 and CH2 with a maximum record length of 1000
frames
• Pass-Fail function compares a stored waveform to an unknown input
• Average Mode for smoothing waveforms
• Square Wave Output (2V, 1kHz) for probe adjustment
• USB Host/Device 2.0 full-speed interface ,support removeable disk, LAN Optional ,Easy to control by PC or longdistance.
• Dimensions (mm):240(L)x165(W)x50(H), be carried easily.
Specification
Model
DSO1202S
DSO1152S
DSO1122S
DSO1062S
Bandwidth
200MHz
150MHz
120MHz
60MHz
Real-time Sample Rate
1GSa/s
Equivalent Sample Rate
25GSa/s
Record Length
Single-channel: Maximum 1M; Dual-channel: Maximum 512K
SEC/DIV Range
2nS/div-2000S/div (in a 2, 4, 8 sequence)
Oscilloscope Mode
Vertical System
Horizontal System
A/D Converter
8-bit resolution
VOLTS/DIV Range
2mV/div～5V/div at input BNC
Position Range
±50V(5V/div),±40V(2V/div～500mV/div),
±2V(200mV/div～50mV/div);±400mV(20mV/div～2mV/div)
Rise Time at BNC
DC Gain Accuracy
≤1.7ns
≤2.3ns
≤2.9ns
≤5.8ns
±4% for Sample or Average acquisition mode, 5mV/div to 2mV/div;
±3% for Sample or Average acquisition mode, 5V/div to 10mV/div.
Trigger System
Trigger Sensitivity(Edge
Trigger Type)
DC: CH1/CH2(Typical) 1div from DC to 10MHz;1.5div from 10MHz to Full;
AC: Attenuates signals below 10Hz;
HF Reject: Attenuates signals above 80kHz;
LF Reject: Attenuates signals below 150kHz;
Noise Reject: Reduces trigger sensitivity;
Trigger Level Range
CH1,CH2: ±8 divisions from center of screen
Hold off Range
100ns-10s
Trigger Level Accuracy
(signals having rise and fall
times ≥20ns)
CH1,CH2: ±(0.3div×V/div) (within ±4 divisions from center of screen)
Edge
Trigger on the rising or falling edge
Video
Trigger on an NTSC, PAL, or SECAM standard video signal; Line Range: 1-525
(NTSC), 1-625 (PAL/SECAM)
Slope
Trigger (when >,<,=,≠) on a positive or negative slope; Set Time: 20ns–10s
Overtime
From the rising or falling edge; Set Time: 20ns-10s
Alternate
Internal trigger on edge, pulse width, video or slope
Measurement
Cursors
Manual: The difference between voltage cursors △V; the difference between time
cursors △T; 1/△T calculated by Hz.
Tracing: The voltage and time at a waveform point
Automatic(32)
Frequency, Period, Mean, Pk-Pk, Cycli RMS, Minimum, Maximum, Rise time, Fall
Time, +Pulse Width, -Pulse Width, Delay1-2Rise, Delay1-2Fall, +Duty, -Duty,
Vbase, Vtop, Vmid, Vamp, Overshoot, Preshoot, Preiod Mean, Preiod RMS,
FOVShoot, RPREShoot, BWIDTH、FRF、FFR、LRR、LRF、LFR、LFF
Meter mode
Max. Resolution
6,000 Counts
DMM Testing Modes
Voltage, Current, Resistance, Capacitance, Diode & Continuity
Max. Input Current
AC: 10A, DC: 10A
Input Impedance
10 MΩ
Isolation
The float voltage between
BNC and Ground
600V CATIII, 1000V CAT II
The float voltage between
each Channel
600V CATIII, 1000V CAT II
The float voltage between
Multimeter and Ground
1000V
between input Ports directly
400V CAT II
Input by 10:1 probe
600V CATIII, 1000V CAT II
The Max input voltage of
Multimeter
The float voltage between Multimeter and Ground
Other
Display Type
Right angle 5.6 16-digit color LCD
Display Resolution
640*480 dots
Display Contrast
16 gears, with the progress bar to show adjustment
Interface
USB host and USB slave, LAN Optional
Voltage
DC Input:12--17VDC, 2000mA
Size
245 x 163 x 52 (mm)
Weight
1KG
Software Support
Operating System: Windows NT, Windows 2000, Windows XP, VISTA, Windows 7.