0/1-10V Dimmer Series
DM9103
SUMMARIZE:
This series is 0/1-10V dimmers for led strip and other constant voltage or constant current led lamps,we offer AC
and DC input products.No flicker on low brightness.We use logarithmic brightness curve to get smooth and good
sense for eyes.They all compatible with products of Lutron,Dynalite,Clipsal,LDS,Osram,Philips,ABB,Schneider,
Levition,JUNG,Berker,Be Lichtregler etc.
Keywords:
Keywords:0-10V DIMMER,1-10V DIMMER,PWM DIMMER,0-10V DRIVER,1-10V DRIVER,LED DIMMER,LED
DIMMABLE DRIVER.
Features
Features::
◆ Analog Signal driver,receive 1-10V dim signal.
◆ Single channel constant voltage output,Max.8A per channel.
◆ Support active and passive to use.
◆ With the self-test function, support short circuit and over current protection functions.
◆ When the power turn off,it has memory function.
Tech-parameter:
Input: DC12-24V
Output: <8A
Control channels:1CH
MAX Power: 180W
Protection grade: IP40
Frequence: 500HZ
Gross product: 210g
Signal Input:active&passive 0/1-10V signal
Work Temp.：0~70℃
The light gray level: 256
Product size: L160*W47*H22(mm)/Custom-made
Size:
Update 2012-10-22
Page 1 of 3
DM9103-V1.1
Function Instructions:
Operation explanation
explanation::
◆First way is selecting switch panel to dimming (normally open panel switch mode), must
put the interface (SWITCH DIM) short
circuit.
◆ When short time press the switch is opening or closing state, the booting has memory and brightness delay light or dark function.
Can realize switch light once light up or down instant.
◆When press the switch with a long time,the brightness plus or minus state, long press process then stop, and in 2 seconds again
continue long press, so it will keep at the last time brightness state, if is over 2 seconds long press again, then brightness will be instead
state control (example: the current light state is added brightness, when adjust to 50% brightness stop, if in 2 seconds long press again,
then the brightness from 50% to continue upward, or it will down from 50% brightness).
◆The second way, choose active 0/1-10 v or passive signal control, it is necessary to put the line to jumper(SWITCH DIM line
break down), according to the product connection diagram, adjust the 0/1-10 v dimmer SWITCH, so as to change the output of the
controller, until get the satisfactory of LED output luminance.
◆In the second way,when the 【Analog IN 】port breaking, controller all light output; When the【 Analog IN 】 port two terminals
short circuit, the output shut down.
Wiring Diagram:
Update 2012-10-22
Page 2 of 3
DM9103-V1.1
Remark:
1. Please choose regulating curve smooth 0/1-10 V dimmer, otherwise it may directly affect the LED dimming smoothness.
2. Load LED's voltage and the controller of power supply voltage must be consistent, and must be in the product prescribed voltage
input range.
3,0/1-10V Active and passive dim signal input can get 0-100% brightness output and the dimming curved path is proportional to the dim
signal.
Update 2012-10-22
Page 3 of 3
DM9103-V1.1