AC/DC Converter Wiring Instructions
AC/DC Converter Wiring
Instructions
The following instructions explain how to wire the AC/DC
converter between the vehicle’s/vessel’s AC power supply and
the TracVision® L3, S3, C3, L2, S2, LF, or SF. The AC/DC converter
compensates for the voltage drop that occurs when using an extendedlength data/power cable.
Materials Provided
The following components are provided with the AC/DC
converter kit.
Part
Part #
AC/DC converter
19-0297
Data/power cable, 45 ft.
32-0730-45
OR
Data/power cable, 60 ft.
32-0730-60
Velcro loop tape, adhesive back
19-0146
Velcro hook tape, adhesive back
19-0348
Figure 1
AC/DC Converter and
Connecting Cables
To TracVision
Switchplate
To Vehicle’s/Vessel’s
AC Power Supply
Wiring the AC/DC Converter
1. Ensure that vehicle/vessel power is turned off.
2. Disconnect the vehicle’s/vessel’s AC power
supply and test the circuit to ensure that no power
is present.
54-0230 Rev. B
Before connecting the AC/DC
converter, be sure the
vehicle/vessel power is turned off
and the vehicle’s/vessel’s AC power
is disconnected.
1
TracVision
Figure 2
AC/DC Converter
DC Power Wires
+12 VDC
(Red)
3. Connect the AC/DC converter’s DC power wires
to the TracVision switchplate. Refer to the
illustration below for your particular TracVision
system. If vehicle/vessel power wires are already
connected to the switchplate, be sure to disconnect
them; they are no longer needed.
+12 VDC
(Red)
Ground
(Black)
Ground
(Black)
Figure 3
Connecting the DC Power Wires
(TracVision L3, S3, C3)
Figure 4
Connecting the DC Power Wires
(TracVision L2, S2, LF, SF)
+12 VDC
(Red)
Ground
(Black)
4. Plug the AC/DC converter’s AC power cord into
the vehicle’s/vessel’s AC power supply.
5. Securely mount the AC/DC converter to a solid
structure using the supplied Velcro tape.
6. Reconnect the vehicle’s/vessel’s AC power supply.
Be sure to follow the appropriate instructions in the TracVision
Owner’s Manual to complete the TracVision installation.
2
54-0230 Rev. B