:
Installation of this equipment should only be performed by skilled personnel such as
qualified electricians and Certified Renewable Energy (RE) System Installers.
120/240 Vac or
240 Vac only
Grid (AC1)
Grid (AC1)
Inverting
Inverting
Flashing = sell
Gen (AC2)
Equalize
Flashing = sell
Gen (AC2)
Fault /
Warning
Charging
Battery
Fault /
Warning
Equalize
Charging
Battery
24 Vdc or 48 Vdc
All configurations must comply with local and national
electrical code jurisdiction. Consult your local certified
installer or local electrical authority to ensure compliance.
975-0238-01-01 Rev A.vsd 4/24/2007
© 2007 Xantrex Technology Inc.
The following information is a list of basic steps required to install an XW Inverter/Charger.
Actual installation procedures will vary depending upon the configuration of the intended
system.
xantrex
Grid
(AC1)
Inverting
Flashing =
sell
Gen
(AC2)
Fault /
Warning
Equalize
Charging
Battery
Hybrid Inverter/Charger
Hybrid
Inverter/Charger
24 Vdc or 48 Vdc
975-0238-01-01 Rev A.vsd/SI(6)/April 24, 2007
© 2007 Xantrex Technology Inc.
Vented Battery Enclosure
All configurations must comply with local and national
electrical code jurisdiction. Consult your local certified
installer or local electrical authority to ensure compliance.
All configurations must comply with local and national
electrical code jurisdiction. Consult your local certified
installer or local electrical authority to ensure compliance.
xantrex
AC LEGEND
Grid (AC1)
Neutral
Inverting
Flashing = sell
Gen (AC2)
Fault /
Warning
Charging
Equalize
Battery
HOT L1
NEUTRAL
HOT L2
L2
L1
Ground
GROUND
L1
AC OUT
AC IN
AC IN
Inv
OUT
Grid
GEN
N
L2
L1
N
L2
L1
N
L2
Hybrid Inverter/Charger
(+)
(–)
(+)
(–)
ON
L1
L2
OFF
G
N
Fuse Block
(optional)
BATTERY
LEGEND
FUSE
FUSE
CLASS TT
CLASS
300 AMP
AMP
300
Negative (–)
Negative (–)
Positive (+)
Positive (+)
24 Vdc or 48 Vdc
xantrex
975-0238-01-01 Rev A.vsd/SI Wiring(7)/April 24, 2007
© 2007 Xantrex Technology Inc.
Ground
xantrex
Grid
(AC1)
Invertin
g
Flashin
g = sell
Gen
(AC2)
Fault /
Warnin
g
Equaliz
e
Chargin
g
Battery
xantrex
BA
PV PV
XWBAT
Solar
Charge
T+ –
+
–
Hybrid Inverter/Charger
Controller
XW Power Distribution Panel
XW Conduit Box
Battery Bank
Vented Battery
Enclosure
975-0238-01-01 Rev A.vsd/SI RE Solar(8)/April 24, 2007
© 2007 Xantrex Technology Inc.
All configurations must comply with local and national
electrical code jurisdiction. Consult your local certified
installer or local electrical authority to ensure compliance.
N
xantrex
AC LEGEND
Grid
(AC1)
Inverting
Flashing
= sell
Gen
(AC2)
Fault /
Warning
Neutral
Chargin
g
Equalize
AC Breakers
AC Breakers
Battery
INV 1
IN
Bypass
(See Note 1)
INV 1
OUT
GEN
HOT L1
xantrex
xantrex
HOT L2
Ground
BAT BAT PV
+
–
–
PV +
(–)
AC OUT
AC IN
AC IN
Inv
OUT
Grid
GEN
L1
N
L2
L1
N
L2
L1
N
PV
+
BAT +
PV –
BAT –
L2
Mppt
PV
DC Disconnects
Hybrid Inverter/Charger
(+)
(–)
L1
L2
G
N
DC LEGEND
Negative (–)
120/240 Vac or
240 Vac only
Positive (+)
Ground
BTS Communication
Cable
BATTERY
LEGEND
All configurations must comply with local and national
electrical code jurisdiction. Consult your local certified
installer or local electrical authority to ensure compliance.
Negative (–)
Battery Temperature Sensor
(BTS)
975-0238-01-01 Rev A.vsd/SI RE Wiring (Solar)(9)/April 24, 2007
© 2007 Xantrex Technology Inc.
Positive (+)
xantrex
Ground
If no Grid is available,
the generator can be
connected to the AC breakers
in the XW Power Distribution
Panel, instead of to a separate
AC breaker.
Charge/Diversion
Load Controller
C-Series
xantrex
Grid
(AC1)
Invertin
g
Flashing
= sell
Gen
(AC2)
Chargin
g
Fault /
Warning
Equaliz
e
Battery
Hybrid Inverter/Charger
XW Power Distribution Panel
DC In
XW Conduit Box
975-0238-01-01 Rev A.vsd/SI RE DL(10)/April 24, 2007
© 2007 Xantrex Technology Inc.
Vented Battery
Enclosure
All configurations must comply with local and national
electrical code jurisdiction. Consult your local certified
installer or local electrical authority to ensure compliance.
XW Inverter/Charger
Communication Ports
L2
G
N
BTS
CM/CMR
BAT
POS
L1
PV/Load
POS
COM
NEG
COM
NEG
(on Bottom of Inverter)
N
xantrex
AC Breakers
INV 1
IN
Bypass
(See Note 1)
GEN
INV 1 OUT
AC LEGEND
Neutral
HOT L1
(–)
HOT L2
Ground
L1
AC OUT
AC IN
AC IN
Inv
OUT
Grid
GEN
N
L2
L1
N
L2
L1
N
DC Disconnect
L2
Mppt
PV
Hybrid Inverter/Charger
All configurations must comply with local and national
electrical code jurisdiction. Consult your local certified
installer or local electrical authority to ensure compliance.
If no Grid is available, the generator
can be connected to the AC breakers in the
XW Power Distribution Panel, instead of to a
separate AC breaker.
975-0238-01-01 Rev A.vsd/SI RE DL Wiring(11)/April 24, 2007
© 2007 Xantrex Technology Inc.
Vented Battery
Enclosure
xantrex
xantrex
Grid
(AC1)
Equaliz
e
Grid
(AC1)
Invertin
g
Flashin
g = sell
Gen
(AC2)
Fault /
Warnin
g
xantrex
Invertin
g
Flashin
g = sell
Gen
(AC2)
Fault /
Warnin
g
Chargin
g
Equaliz
e
Battery
Chargin
g
Battery
xantrex
PVCharge Controller
PV
XW Solar
BAT BAT
+
–
Hybrid Inverter/Charger
Hybrid Inverter/Charger
–
+
XW Power Distribution Panel
xantrex
PVCharge Controller
PV
XW Solar
BAT BAT
+
–
XW Conduit Box
975-0238-01-01 Rev A.vsd/DI RE Solar(12)/April 24, 2007
© 2007 Xantrex Technology Inc.
–
+
XW Conduit Box
Vented Battery
Enclosure
All configurations must comply with local and national
electrical code jurisdiction. Consult your local certified
installer or local electrical authority to ensure compliance.
All configurations must comply with local and national
electrical code jurisdiction. Consult your local certified
installer or local electrical authority to ensure compliance.
AC LEGEND
N
xantrex
xantrex
AC Breakers
INV 1 IN
(Grid)
INV 2 IN
(Grid)
Grid
Bypass
L2
G
N
XW Solar
Charge
Controller
Neutral
HOT L1
L1
(See Note 1)
Grid
Bypass
INV 1 OUT
(AC Loads)
INV 2 OUT
(AC Loads)
INV 1 IN
(Gen)
INV 2 IN
(Gen)
HOT L2
xantrex
Ground
Inverter AC
Distribution
Panel
NEUTRAL
L2
L1
BAT BAT PV PV
+
– –
+
(–)
AC OUT
AC IN
AC IN
AC OUT
AC IN
AC IN
Inv
OUT
Grid
GEN
Inv
OUT
Grid
GEN
L1
N
L2
L1
N
L2 L1
N
L1
L2
N
L2
L1
N
L2 L1
N
L2
CC
+
Hybrid Inverter/Charger
CC
+
Mppt
PV
PV
+
PV
+
DC
Disconnects
GROUND
Hybrid Inverter/Charger
xantrex
BAT BAT PV PV
+
– –
+
DC LEGEND
If no Grid is available, the generator can be
connected to the AC breakers in the XW Power
Distribution Panel, instead of to a separate AC breaker.
975-0238-01-01 Rev A.vsd/DI RE Solar Wiring(13)/April 24, 2007
© 2007 Xantrex Technology Inc.
xantrex
24 Vdc or 48 Vdc
BATTERY
LEGEND
Negative (–)
Negative (–)
Positive (+)
Positive (+)
Ground
Ground
xantrex
Grid (AC1)
Charge/Diversion Load
Controller
Charge/Diversion Load
Controller
C-Series
C-Series
xantrex
Grid (AC1)
Inverting
Inverting
Flashing = sell
Flas hing = sell
Gen (AC2)
Gen (AC2)
Fault /
Warning
Fault /
Warning
Charging
Equalize
Charging
Equalize
Battery
Battery
Hybrid Inverter/Charger
XW Power Distribution Panel
Communication
Hybrid Inverter/Charger
DC In
XW Conduit Box
975-0238-01-01 Rev A.vsd/DI RE DL(14)/April 24, 2007
© 2007 Xantrex Technology Inc.
XW Conduit Box
All configurations must comply with local and national
electrical code jurisdiction. Consult your local certified
installer or local electrical authority to ensure compliance.
All configurations must comply with local and national
electrical code jurisdiction. Consult your local certified
installer or local electrical authority to ensure compliance.
L2
G
N
BTS
CM/CMR
BAT
POS
L1
PV/Load
POS
COM
NEG
COM
NEG
N
xantrex
xantrex
Grid (AC1)
Inverting
Flashing = sell
Gen (AC2)
Fault /
Warning
Charging
AC Breakers
(See Note 1)
Equalize
Battery
INV 1 IN
(Grid)
INV 2 IN
(Grid)
Grid
Bypass
Grid
Bypass
INV 1 OUT
(AC Loads)
INV 2 OUT
(AC Loads)
INV 1 IN
(Gen)
INV 2 IN
(Gen)
(–)
AC OUT
AC IN
AC IN
AC OUT
AC IN
AC IN
Inv
OUT
Grid
GEN
Inv
OUT
Grid
GEN
L1
N
L2
L1
N
L2
L1
N
L1
L2
N
L2
L1
N
L2
L1
N
L2
Mppt
PV
DC Disconnects
Hybrid Inverter/Charger
Hybrid Inverter/Charger
BTS Communication
Cable
If no Grid is available, the generator can be connected
to the AC breakers in the XW Power Distribution Panel, instead
of to a separate AC breaker.
xantrex
975-0238-01-01 Rev A.vsd/DI RE DL Wiring(15)/April 24, 2007
© 2007 Xantrex Technology Inc.
Battery Temperature
Sensor (BTS)
Vented Battery
Enclosure