Page 1 of 2
04.29.13
Instructions for Installation:
C-10481 Prosecco Chandelier
Lamping Specifications:
Incandescent: Candelabra Base,
Eight, B-10, 60w max each
IMPORTANT! AT ALL TIMES WIRING
TO BE DONE PER NATIONAL ELECTRIC
CODES (NEC) OR APPLICABLE LOCAL
CODES
IMPORTANT | CAUTION
READ ALL INSTRUCTIONS THOROUGHLY.
TURN OFF POWER AT CIRCUIT BREAKER OR
FUSE BOX BEFORE PROCEEDING.
Step 1 Carefully remove the fixture and shades from packaging. Avoid using a sharp blade on the packaging, as doing so
may result in damage to the fixture, canopy, shades or misc
deco parts.
Step 2 Turn off power at fuse box/circuit breaker.
Important: Read all instructions thoroughly. Be sure that all
wiring to follow national and local electrical codes.
Step 3 Locate and attach the mounting bracket to the junction box located in the ceiling. (See Figure 1)
Figure 4
Step 4 Attach the fixture canopy assembly to the mounting bracket and secure into position using the four knurled
thumb knobs that are provided. (See Figure 2)
Figure 1
Step 5 Attach the decorative suspension chain to the chandelier body. Orient the decorative ring on the suspension chain
with the chain mount bracket located on the chandelier
body. Secure the deco ring into the chain mountain bracket
with the retainer screw. (See Figure 3)
Step 6 Carefully lift the chandelier assembly up towards the
canopy and attach the top chain link onto the hanger hooks
located on the canopy assembly. Make sure that the chain
links have not become twisted or kinked when fully extended and ensure that the fixture hangs properly. (See Figure 4)
Figure 2
Figure 5
Step 7 Thread the steel set screws into the hanger hooks
located on the canopy assembly. This hardware will ensure
that the chain link will be securely locked onto the hanger
hook assembly. (See Figure 5)
Step 8 Carefully route the fixture power cord up and along
the chain links. Route the cord through the links skipping
every other link in the chain. (See Figure 6)
Figure 3
Figure 6
BOYD LIGHTING · 30 LIBERTY SHIP WAY SUITE 3150 · SAUSALITO CA 94965
TEL
415.778.4300 · FAX 415.778.4319 · BOYDLIGHTING.COM
Page 2 of 2
Step 12 Remove the upper shade ring and install the shade
onto the fixture socket. Secure the shade onto the socket with
the shade ring, do not overtighten as this can damage the socket
or shade ring. Remove the shade cover and use care not to leave
smudges or finger prints on the shade fabric. (See Figure 9)
Step 13 Install a candelabra base “B”type lamp. Do not exceed
relamp label specifications as this can damage the shade.
Step 14 Restore power to circuit and illuminate lamps.
Figure 7
Step 9 Route the fixture cord through the canopy cover
and make connections with the supply wires at the junction box. (See Figure 7)
Step 10 Connect the neutral fixture wire (ribbed) to the
neutral supply wire; typically white, connect the load
fixture wire (smooth)to the hot supplywire; typically
black, connect the copper fixture canopy wire to the
ground wire and/or the ground terminal in the outlet
box. Push all connections inside of junction box.
Step 11 Lift the canopy cover up to the canopy and align
the center hole with the threaded hardware. Secure the
cover against the canopy with the decorative machined
cap. (See Figure 8)
Figure 9
Figure 8
BOYD LIGHTING · 30 LIBERTY SHIP WAY SUITE 3150 · SAUSALITO CA 94965
TEL
415.778.4300 · FAX 415.778.4319 · BOYDLIGHTING.COM