WEEK 15
15.0 ASSEMBLY DRAWING
15.1
Bracket and Glad Assembly
Figure 15
Figure 15 shows the details of the parts of a bracket and gland assembly.
Details drawings of the parts of a bracket and gland assembly are given in Figure15.
The studs are fitted into the holes A. The packing is then inserted into the 38mm
diameter hole at D, following by the gland, which is fitted so that the 11mm diameter
holes pass over the projecting studs. The washers and nuts are then fitted to the studs
and the nuts tightened. Do not draw the given views but make the following views,
full size, of the assembly, in first angle projection:
(a) A sectional elevation, the plane of the section and the direction of the required
view being indicated at BB.
(b) Half of a sectional elevation, the plane of the section and the direction of the
required view being indicated at CC. Draw that half which appears on the left
of the vertical centre line.
(c) A half plan. Draw that half which appears above the horizontal centre line, in
plan.