Accessing the SPA2100's Web−Based Setup Page
Document ID: 108786
Contents
IntroductionHow do I access the SPA2100's web−based setup page?Related Information
Introduction
This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business
products.
Q. How do I access the SPA2100's web−based setup page?
A.
All SPA devices have a built−in web−based setup page that allows the user to customize settings and set up
advanced properties. For instructions on how to access the SPA2100's web−based setup page, complete the
steps in this document.
Note: Before accessing the SPA2100's web−based setup page, make sure the router is powered on and the
computer is wired to the LAN port of the SPA unit.
Accessing the SPA2100's Web−Based Setup Page
Step 1:
Open a web browser such as Internet Explorer.
Step 2:
Go to the Address bar and enter the SPA2100's IP Address (by default the IP address of the
SPA2100 is 192.168.0.1) then press [Enter].
The SPA2100's web−based setup page should open.
Note: Access to the SPA2100's Admin Login−Advanced page does not require a password by
default. SPA2100 units acquired though ITSPs, however, are generally password−protected
for security reasons, denying access to the Admin Login and rejecting changes applied to
existing configuration. If the unit is purchased from a reseller, it can be restored to default
settings through factory reset using the IVR. For IVR instructions, click here.
Related Information
• Technical Support &Documentation − Cisco Systems
Updated: Dec 12, 2008
Document ID: 108786