For ConTech Lighting T-Bar Mount Feed Stem Support Kit: LA5112... B 2. Slide the above assembly over the 15/16" T-Bar Grid... D

advertisement
For ConTech Lighting T-Bar Mount Feed Stem Support Kit: LA5112 and LA5118
Standard 15/16" T-Bar Grid Ceiling
Fastener Set Screw (A)
Two-Piece 15/16" T-Bar Fastener (B)
Stabilizing Cast Fitter (C)
Stem (D)
12" or 18" Length
Mounting Bracket Cover (E)
Hex Nuts (F)
Mounting Bracket (G)
1.
2.
3.
4.
5.
6.
7.
8.
9.
Mounting Bracket Set Screw (H)
Attach the base side of the two-piece 15/16" T-Bar Fastener (B) with the fastener set screw (A) to the stabilizing cast fitter (C).
Slide the above assembly over the 15/16" T-Bar Grid Ceiling.
Slide and lock the second piece of the two-piece 15/16" T-Bar Fastener (B) over the 15/16" T-Bar Grid Ceiling.
Thread the stem, 12" or 18" length (D), into the top assembly, which is attached to the 15/16" T-Bar Grid ceiling.
Thread the two Hex Nuts (F) to one end of the stem (D) with the mounting bracket cover (E) above.
Slide the mounting bracket (G) into the top of the track.
Slide the mounting bracket (G) between the two Hex Nuts (F) and tighten.
Tighten set screw (H) to lock the mounting bracket (G) into the track and place mounting bracket cover (E) in position.
Proceed to the next stem installation. Two stems are recommended per 4, 6, and 8 ft. piece of track, three stems per 12
ft. piece of track (Max. 4 ft. C-C).
IMPORTANT SAFETY INSTRUCTIONS:
• Read all the instructions before installation. Save instructions for later use.
• Turn off the power at fuse or circuit breaker box before installation or maintenance work.
• Wear rubber soled shoes and work on a sturdy wooden or non-conductive ladder.
• Product must be mounted in locations and at heights in compliance with National Electrical Code and local building codes. For
indoor use only.
• Do not exceed the nominal supply voltage or amperage ratings.
• Installing contrary to instructions may cause unsafe conditions.
• Warning: Risk of fire. Most dwellings built before 1985 have supply wire rated at 60°C. Consult a qualified electrician before
installation.
• Avoid hazards to children: account for all parts and properly dispose of all packing materials.
• Call the Technical Support department at ConTech Lighting with any installation questions.
All specifications subject to change without notice.
1-847-559-5500
www.contechlighting.com
This document can be recycled.
LA5012 INST
Download