For ConTech Lighting Framing Projector: CTL7516
INSTALLATION PROCEDURES
WARNING: Framing Projector may be dimmed using only dimmers
rated and approved for capacitive loads (Electronic Low Voltage) or
reverse phase control.
Use only with a 75W or smaller lamp.
All track sections have an easy to see embossed polarity line. All
Con-Tech Track Fixtures have indicator arrows that must point to the
track polarity line.
To install:
a) Insert fixture contacts into track channel.
b) Retract track latch by gently pulling down.
c) Rotate track adaptor 90° so polarity arrow points to polarity line
on the track.
When fixture is installed, the track latch will lock fixture into track.
NOTE: All latches should face the same direction after installation.
Track Connector
Electronic
Transformer
Gobo/Pattern Holder
Gel/Color
Media
Holder
Lamp
Removal
Plate
Lamp
Removal
Knob
Shutters (4)
BEAM ADJUSTMENT
Shutter Adjustment
Insert one corner of the long flat blade into the shutter opening.
(Figure 3)
Push the shutter into fixture as far as necessary to reshape the beam
of light.
DO NOT attempt to push the entire flat end of the blade into the
shutter opening at one time. It does not fit and will damage the shutter.
Focusing
To make the image larger or smaller, or to sharpen the image, loosen
the focus knobs and move them forward or backward (depending on
the size and detail of the gobo).
Focus Adjustment Knobs
Polarity Line
IMPORTANT SAFETY INSTRUCTIONS:
• Read all the instructions before installation. Save instructions for
later use.
• Turn off power at fuse or circuit breaker box before installation or
before doing any maintenance work.
• Wear rubber soled shoes and work on a sturdy wooden or nonconductive ladder.
• Product must be mounted in locations and at heights in a manner
consistent with its intended use, and in compliance with National
Electrical Code and local building codes. For indoor use only.
• Do not exceed the nominal supply voltage or amperage ratings.
• Do not install any lampholder closer than 6" from any curtain or
similar combustible material.
• Installing contrary to instructions may cause unsafe conditions.
• Warning: Risk of fire. Most dwellings built before 1985 have supply
wire rated at 60°C. Consult a qualified electrician before installation.
• Warning: Risk of burns. Lamps are extremely hot when lit. Allow
lamps to cool down in temperature before handling.
• To avoid hazards to children, account for all parts and properly
dispose of all packing materials.
• Call the Technical Support department at ConTech Lighting with any
installation questions: 847.559.5500.
Track Latch with
Polarity Arrows
All specifications subject to change without notice.
1-847-559-5500
www.contechlighting.com
This document can be recycled.
CTL7516 INST